Lower Front Bezel; Removing The Lower Front Bezel; Installing The Lower Front Bezel - HP Z600 Maintenance And Service Manual

Lower front bezel

This section describes how to remove and install the lower front bezel.

Removing the lower front bezel

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the right side panel (see
4. Remove the two lower front bezel screws from the bottom of the chassis as shown in the following
figure.
Figure 5-12
5. Rotate the bezel out and upward on the chassis to remove it.

Installing the lower front bezel

To install the lower front bezel, place the bezel on the chassis and install the screws.
84 Chapter 5 Replacing components
Removing the right side panel on page
Removing the lower front bezel
Predisassembly procedures on page
Removing the side access panel on page
73).
75).
78).
ENWW