Power Switch Cable Assembly; Removing The Power Switch Cable Assembly - HP Z600 Maintenance And Service Manual

Power switch cable assembly

This section describes how to remove and install the power switch cable assembly.

Removing the power switch cable assembly

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the right side panel (see
4. Remove the upper front bezel (see
5. Remove the screw from the power switch cable assembly as shown in the following figure.
Figure 5-17
88 Chapter 5 Replacing components
Removing the right side panel on page
Removing the upper front bezel on page
Removing the power switch cable assembly
Predisassembly procedures on page
Removing the side access panel on page
73).
75).
78).
83).
ENWW