HP Z600 Maintenance And Service Manual page 147

6. Angle the card into the expansion card guide. Align the PCIe card keyway with the slot key, and
then firmly seat the card in the slot as shown in the following figure
If required by the card, connect the auxiliary power cable to the card (not illustrated), or other cables
or accessories described in the card instructions.
Figure 5-78
7. Close the expansion card retention clamp by rotating it downward
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.
ENWW
Installing a PCIe card
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
.
.
2
Removing and installing components 135