Side Access Panel Solenoid Lock; Cable Lock (Optional) - HP Z600 Maintenance And Service Manual

Setting the Side access panel sensor protection level
To set the Side access panel sensor protection level:
1. Power on or restart the workstation.
2. As soon as the workstation is powered on, press and hold the
Setup (F10) Utility. Press
NOTE:
and then press and hold the
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
3. Select Security>Smart Cover>Cover Removal Sensor, and follow the onscreen instructions.
4. Before exiting, select File>Save Changes and Exit.

Side access panel solenoid lock

The side access panel solenoid locks the side access panel to the chassis. The solenoid is controlled
by a local or remote signal.
To lock the solenoid, set a password for the solenoid lock in the Computer Setlup (F10) Utility. To unlock
the solenoid, remove the solenoid lock password in the Computer Setup (F10) Utility.
The solenoid lock FailSafe Key–available from HP–is is a device for manually disabling the solenoid
lock. You will need the FailSafe Key in case of forgotten password, power loss, or workstation
malfunction.

Cable lock (optional)

To prevent theft, the rear chassis panel of the workstation accommodates a keyed cable lock. This cable
lock attaches to the chassis and secures it to the work area. (See
for component locations.)
ENWW
Enter
If you do not press the
F10
to bypass the title screen, if necessary.
F10 key at the appropriate time, you must restart the workstation,
key again to access the Computer Setup (F10) Utility.
F10 key until you enter the Computer
Rear panel components on page 7
Workstation management 59