HP Z600 Maintenance And Service Manual page 122

5. Lift and hold the drive release latch at the green touch point
into the bay. When the front of the carrier is near its final position, release the latch, but continue
to slide the carrier inward until the latch closes and engages the carrier
NOTE:
Figure 5-48
6. Connect the chassis power cable to the hard disk drive power connector as shown in the following
figure.
TIP: Place excess cabling in the slot load bay.
Figure 5-49
110 Chapter 5 Replacing components
Install the slot load optical bay with the slot load drive at the top.
Installing the slot load carrier in the chassis
Connecting chassis power cable to hard disk drive connector
while sliding the slot load carrier
.
2
ENWW