Surround Parameter Tone - Denon AVR-2309CI Owner's Manual

ENGLISH
[Selectable items]
.11]
5B CH Out
(for 2-channel sources)
Determine whether to use surround back speakers.
ON
OFF
The surround back channel signal is played.
The surround back channel signal is not played
Tone
Adjust the tonal quality of the sound.
Bil
Tone Control
Turn tone adjustments off.
udyssey Settings
ect room equalizer for current environment.
m
MultEQ
Select the type of room correction desired from the following list:
The tone cannot be adjusted when in the DIRECT mode.
1m
Bass
Adjust low frequency range (bass).
-n·o-
When the "Dynamic EO" setting is "ON': setting is not possible.
[Selectable items]
ON
Playback without tone adjustment.
~:
Allow tone adjustment (treble, bass)
[Selectable items]
Audyssey
Optimize frequency response of all speakers.
Audyssey Byp. UR
Optimize frequency response of speakers
except front Land R speakers.
Audyssey Flat
Optimize frequency response of all speakers
to flat response.
Manual
Apply frequency response set with "Manual
EO" (02W'page 34)
OFF
I:
Turn equalizer off.
• Audyssey - - - Audyssey Byp. L/R ~
C
OFF Manual - - - Audyssey Flat
-----J
-6dB - -HidB
[Variable range]
Attenuate subwoofer level when using EXT IN mode.
[Selectable items]
Set this to "ON" if the subwoofer channel level seems too high when
playing audio signal.
ON :
The input from the subwoofer channel is attenuated.
~:
The input from the subwoofer channel
IS
not attenuated.
Usually use in this mode.
Bi1
5ubwoofer
lID
5W ATT (5UBWOOFERATT.)
I
"Bass" and "Treble" can be set when "Tone Control" is set to "ON':
11
Treble
Adjust high frequency range (treble).
Turn subwoofer output on and off.
[Selectable items]
~:
The subwoofer is used.
OFF .
The subwoofer is not used.
II
Default
Resets the settings to the default values.
[Variable range]
-6dB - -HidB
~ Operating from the main unit or main remote
control unit
Press
MULTEn.
• When "Audyssey", Audyssey Byp. UR" or "Audyssey Flat" is
selected, " ~~::'.'i,'bSEY " lights.
• After running Auto Setup, if the Speaker Configuration, Distance,
Channel Level, and Crossover Frequency have changed without
increasing the number of speakers measured, only
"~~::'.'i,'bSEY"
lights.
• "Audyssey", "Audyssey Byp. UR" and "Audyssey Flat" can be
selected after the auto setup procedure has been performed.
• After performing "Auto Setup", the "MultEO" setting automatically
becomes" Audyssey".
• If the settings of speakers for which" None" has been determined
at "Auto Setup" are changed, "Audyssey': "Audyssey Byp UR" and
"Audyssey Flat" cannot be selected. Either perform Auto Setup
again, or return to the setting after running Auto Setup with "Auto
Setup" - "Parameter Check" - "Restore".
• MultEO and Manual EO set to "Not Used" with "Manual Setup"
- "Audio Setup" - "EO Preset" - "EO Customize" 10000page 34) on
the menu, cannot be selected.
• When using headphones, "MultEO" is set to "OFF':
49
I
For details on adjusting individual parameters, see "Adjusting the parameters" (Gf'page 46).