Multi-Zone; External Controller - Denon AVR-2309CI Owner's Manual

ENGLISH
Multi-zone External Controller
I
RS-232C connector
This connector is used for an external controller.
:>.:: If you wish to control the AVR-2309CI from
an external controller using the RS-232C
connector, perform the operation below
beforehand.
CD
Turn on the AVR-2309CI's power.
l!i!'i~~~~~@~~~@~
• . .
~ ~o~~~o~~~.~~(g)~.~""'@
Turn off the AVR-2309CI's power from the
external controller.
@ Check that the AVR-2309CI is in the standby
mode.
-AUDIO-
AUDIO
IN
L A
~~
Pre-main amplifier
(ZONE2)
ZONE2 out Connections
If another pre-main (integrated) amplifier is connected, the ZONE2 out connectors can be used to playa
different program source in ZONE2 at the same time (&page 69 - 72).
.~[.}j.
• For the audio output, use high quality pin-plug cords so that no induction humming
or
noise is produced.
• For instructions on installing and operating separately sold devices, refer to the respective devices'
operating instructions.
• To conduct multi-zone playback, see" Amp Assign / Multi-zone Connections and Operations" ((W'page
69 - 72)
AUX
°rU;T:;;;;;:~;I~np~u~t!!.....!!:Joutput
Infrared
tr
I±l
[±l
retransmitter
rl:~~~c:::::J~~Im-f'il
EQ)
" G B
Infrared
sensor
Extension jack for future use.
(Connect devices corresponding with room to
room function to this jack)
• When using in combination with an RF Remote Controller (RC-7000CI, sold separately) or RF Remote
Receiver (RC-7001 RCI, sold separately) two-way communication with an RF Remote Controller is
possible.
The AVR-2309CI's status information as well as iPod can be browsed watching the RF Remote
Controller's display. For details, refer to the operating instructions of the respective devices .
• When used in combination with an RF Remote Controller or RF Remote Receiver, make the settings at
menu "Manual Setup" - "Option Setup" - "232C Port" - "2Way Remote" ((W'page 37) .
• On the menu, when setting "Manual Setup" - "Option Setup" - "232C Port" to "2Way Remote", you
cannot use the RS-232C port as an external controller ((W'page 37).
Trigger output jack
The power of an external device equipped with
a trigger input jack can be turned on and off in
association with operations on the AVR-2309CI.
For details, see menu "Manual Setup" - "Option
Setup" - "Trigger Out" ((W'page 36, 37)
• Output DC 12 V 150 mA MAX.
Check the trigger input conditions of the
connected device.
20