Dial Plan - Linksys SPA941 Administration Manual

Jitter
Round Trip Delay
Packets Lost
Packet Error
Mapped RTP Port
Downloaded Ring Tone
Status
Ring Tone 1
Ring Tone 2

• Dial Plan

The SPA allows each extension to be configured with a distinct dial plan. The dial plan specifies how to
interpret digit sequences dialed by the user, and how to convert those sequences into an outbound dial
string.
The SPA syntax for the dial plan closely resembles the corresponding syntax specified by MGCP and
MEGACO. Some extensions are added that are useful in an end-point.
The dial plan functionality is regulated by the following configurable parameters:
•
Interdigit_Long_Timer
•
Interdigit_Short_Timer
•
Dial_Plan (unique per extension)
Other timers are configurable via parameters, but do not directly pertain to the dial plan itself. They are
discussed elsewhere in this document.
Interdigit Long Timer:
ParName: Interdigit_Long_Timer
Default: 10
The Interdigit_Long_Timer specifies the default maximum time (in seconds) allowed between dialed
digits, when no candidate digit sequence is as yet complete (see discussion of Dial_Plan parameter for
an explanation of candidate digit sequences).
© 2003 - 2005 Linksys, a Division of Cisco Systems
Receiver jitter in milliseconds
Network round trip delay (ms); available if the peer supports RTCP
Total number of packets lost
Number of RTP packets received that are invalid
NAT mapped RTP port
Indicates whether the phone is downloading a ring tone (and from where) or idle
Information about the user downloaded ring tone 1: name, size, and time-stamp
of the tone
Information about the user downloaded ring tone 2: name, size, and time-stamp
of the tone
Proprietary (See Copyright Notice on Page 2)
DRAFT
77