Linksys SPA941 Administration Manual page 55

Reg Min Expires
Reg Max Expires
Reg Retry Intvl
Reg Retry Long
Interval
Response Status Code Handling
Parameter Name
1
SIT1 RSC
1
SIT2 RSC
1
SIT3 RSC
1
SIT4 RSC
Try Backup RSC
Retry Reg RSC
RTP Parameters
Parameter Name
2
RTP Port Min
2
RTP Port Max
RTP Packet Size
Max RTP ICMP Err
4
RTCP Tx Interval
© 2003 - 2005 Linksys, a Division of Cisco Systems
31
Range: 0 – (2 – 1)
Minimum registration expiration time allowed from
the proxy in the Expires header or as a Contact
header parameter. If proxy returns something less
this value, then the minimum value is used.
Maximum registration expiration time allowed from
the proxy in the Min-Expires header. If value is
larger than this, then the maximum value is used
Interval to wait before the SPA retries registration
again after encountering a failure condition during
last registration
When Registration fails with a SIP response code
that does no match <Retry Reg RSC>, the SPA
will wait for the delay specified in this parameter
before retrying. If this parameter is 0, the SPA will
stop retrying. This value should be much larger
than <Reg Retry Intvl> which should not be 0.
Description
SIP response status code to INVITE on which to
play the SIT1 Tone
SIP response status code to INVITE on which to
play the SIT2 Tone
SIP response status code to INVITE on which to
play the SIT3 Tone
SIP response status code to INVITE on which to
play the SIT4 Tone
SIP response status code on which to retry a
backup server for the current request
Interval to wait before the SPA retries registration
again after encountering a failure condition during
last registration
Description
Minimum port number for RTP transmission and
reception
Maximum port number for RTP transmission and
reception
Packet size in sec. Valid values must be multiple of
0.01s. Range: 0.01 – 0.16
Number of successive ICMP errors allowed when
transmitting RTP packets to the peer before the
SPA will terminate the call. If value is set to 0, the
SPA will ignore the limit on ICMP errors.
Controls the interval (sec) to send out RTCP
sender report on an active connection.
Range: 0 – 255 (s)
Time0
Time0
Time0
Time0
Type
RscTmplt
RscTmplt
RscTmplt
RscTmplt
RscTmplt
Time0
Type
Port
Port
Time3
Uns32
Time0
Proprietary (See Copyright Notice on Page 2)
DRAFT
1
7200
30
1200
Default
30
Default
16384
16482
0.03
0
0
55