Memory Programming; General; Programming The Memory/Call Channels - Icom IC-V8 Instruction Manual

6

General

The transceiver has 100 memory channels (plus 3 pairs of scan
edges and 1 call channel) for storage of often-used frequencies.
D Memory channel contents
The following information can be programmed into the memory:
• Operating frequency
• Duplex direction (+ or –) with an offset frequency (pgs. 21, 22)
• Subaudible tone encoder or tone squelch ON/OFF (pgs. 21, 35)
• Subaudible tone and tone squelch frequencies (pgs. 22, 36)
• Skip information* (p. 32)
*Except for scan edge channels.
Programming the memory/call
channels
q
Push [D•
w
Set the desired frequency.
e
Set other information such as tone, duplex, etc. as desired.
r
Push [C•
[A•
FUNC
channel and return to VFO
• Continue to hold [C•
sec. after 3 beeps are emitted, to in-
crement the displayed memory chan-
nel number
25

MEMORY PROGRAMMING

] to select VFO mode, if necessary.
CLR
] for 1 sec. (until 3 beeps emitted) after pushing
MR
] to program the information into the displayed memory
MR
.
] down for 1
MR