Cadillac CTS 2013 Owner's Manual page 66

3-8 Seats and Restraints
(Exit Button): Moves the driver
seat and/or power steering column
to the exit position. See Exit Recall
later in this section.
Storing Memory Positions
To save into memory:
1. Adjust the driver seat, outside
mirrors, and the power steering
column (if equipped) to the
desired driving positions.
2. Press and hold 1 until two
beeps sound.
3. Repeat for a second driver
using 2.
The vehicle comes with two Remote
Keyless Entry (RKE) transmitters.
Each transmitter has a number 1
or 2 on it. These numbers
correspond to 1 and 2 on the
driver door. The current driver is
identified when on the RKE
transmitter is pressed, or when 1
or 2 on the driver door is pressed.
To recall, press and release 1 or
2. The vehicle must be in P (Park)
for an automatic transmission, or the
parking brake must be applied for a
manual gearbox. A single beep
sounds when the button is pressed.
The seat, outside mirrors, and/or
power steering column move to the
position previously stored for the
identified driver.
Automatic Entry Recall
If entry/exit recall is programmed on
in the vehicle personalisation menu,
automatic entry recall occurs when
the ignition is turned on. See
Vehicle Personalisation on
page 5 47.
To stop recall movement, press one
of the power seat, memory,
or outside mirror buttons, or the
power steering column switch (if
equipped).
If something has blocked the driver
seat or the steering column while
recalling a memory position, the
recall may stop. Remove the
obstruction; then press the
appropriate control for the area that
is not recalling for two seconds. Try
recalling the memory position again
by pressing the appropriate memory
button. If the memory position is still
not recalling, see your dealer for
service.
Exit Recall
(Exit Button): Press to move
the driver seat back a preset
distance and/or the power steering
column (if equipped) up and
forward. A single beep sounds when
the exit feature activates. The
vehicle must be in P (Park) for an
automatic transmission or the
parking brake must be applied for a
manual gearbox.
If entry/exit recall is programmed on
in the vehicle personalisation menu,
automatic seat and/or steering
column movement occurs upon
leaving the vehicle, if the following
conditions are met. See Vehicle
Personalisation on page 5 47.