Cadillac CTS 2013 Owner's Manual page 35

6. Place the new transmitter into
the transmitter pocket with the
buttons facing the front of the
vehicle. The transmitter pocket
is inside the centre console
storage area between the driver
and front passenger seats.
7. A beep sounds once the
transmitter is programmed. The
DIC displays READY TO LEARN
ELECTRONIC KEY #3 OR 4 or
MAXIMUM # ELECTRONIC
KEYS LEARNED.
8. Press the ignition control knob to
exit programming mode.
9. Remove the transmitter from the
transmitter pocket and press
on the keyless access
transmitter two times.
10. To program additional
transmitters, repeat Steps 6
through 9.
Starting the Vehicle with a Low
Transmitter Battery
Replace the battery if the REPLACE
BATTERY IN REMOTE KEY
message displays in the DIC. See
Replace Battery In Remote Key
under Key and Lock Messages on
page 5 38 for additional information.
If the transmitter battery is weak, the
DIC may display ELECTRONIC
KEY NOT DETECTED when you try
to start the vehicle. To start the
vehicle, place the transmitter in the
centre console storage area
transmitter pocket with the buttons
facing to the front of the vehicle.
Then, with the vehicle in P (Park)
or N (Neutral), press the brake
pedal and the ignition control knob.
Keys, Doors, and Windows
See Starting the Engine on
page 9 15, for additional information
about the vehicle's electronic
keyless ignition with push start.
Replace the transmitter battery as
soon as possible.
Battery Replacement
Make sure that you dispose of old
batteries in accordance with
environmental protection
regulations to help protect the
environment and your health.
When replacing the
battery, do not touch any of the
circuitry on the transmitter. Static
from your body could damage the
transmitter.
2-9
WARNING