Installing the storage subsystem configuration
Using the information gathered in the previous sections, install the host systems
and host adapters.
Notes:
1. See the documentation provided with your host adapters for installation
2. Use the correct host adapter driver. For the latest supported host adapters and
Attach fiber-optic interface cables to each host adapter. You will connect the other
end of the cables to the controller later in the installation process. For more
information about handling fiber-optic cables, see "Installing fiber-optic cables" on
page 36.
Note: Do not install the storage-management software at this time, if it is not
32
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User's Guide
requirements and procedures.
drivers, go to the following Web site:
www.pc.ibm.com/support
already installed. Install the storage server completely before you install the
software because you cannot test the software installation until the hardware
is connected.