Table of Contents
Advertisement
Wire tab
Protective cap
o
90
Figure 70. Unlocking the SFP module latch - wire variety
c. With the SFP latch in the unlocked position, extract the SFP module.
v For SFP modules that contain plastic tabs, slide the SFP module out of
the port.
v For SFP modules that contain wire tabs, grasp the wire latch and pull
the SFP module out of the minihub port.
d. Replace the protective cap on the SFP module.
e. Place the SFP module into a static-protective package.
f. Replace the protective cap on the port.
5. Remove the failed RAID controller (the Fault LED is on), as follows:
a. Push down on the latch (centered above the RAID controller). Pull both
levers at the same time out of the locked position.
Figure 71. Pull-rings for removing a controller
b. Grasp the pull-rings; then pull on the levers and remove the RAID
controller.
6. To access the cache battery, place the RAID controller CRU bottom up on a
flat surface. Using a #2 Phillips head screwdriver, remove the six screws (three
on each side of the RAID controller) that hold the RAID controller bottom panel
to the sides of the RAID controller, as shown in Figure 72 on page 90.
SFP module
Chapter 5. Installing and replacing components
89
Advertisement
Table of Contents
