Setting server ID settings
|
22
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User's Guide
7
7
Figure 16. Rail adjustment screws
8. Remove the white screws and nuts 1 from the storage server bezel; then slide
the storage server into the rack. Align the bezel locator pins and attach the
bezel with two M6 screws 2 ; then install and tighten the 6-32 in. screws 3 .
8
8
Figure 17. Server installation
9. Reverse step 1 through step 4 to reinstall the components that you removed.
See your storage server documentation to complete your installation. Store this
information with the storage server documentation for future use.
The FAStT600 comes with a server ID switch that is used to identify the FAStT600
on a Fibre Channel loop. The server ID switch is located on the back of the unit, as
shown in Figure 18 on page 23.
Note: The Server ID switch is sometimes referred to as an "Enclosure ID" switch.