Connecting the internal battery
To connect the uninterruptible power supply internal battery, complete the following
steps:
1. Make sure that the uninterruptible power supply is turned off and is
2. Remove the uninterruptible power supply front bezel:
3. Loosen the thumbscrew on the metal battery cover and lift up to remove the
12
1000 VA and 1500 VA LCD Tower UPS: Installation and Maintenance Guide
disconnected from the outside power source.
a. Press up on the two bezel latches to release the front bezel 1 and pull up
2 .
Note: A ribbon cable connects the bezel to the uninterruptible power supply.
Do not pull on the cable or disconnect it.
b. Carefully rotate the bezel 180° and place it on top of the uninterruptible
power supply 3 .
cover.