Tv Tuner Module - HP SignagePlayer mp8000r Maintenance And Service Manual
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
TV Tuner Module
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the optical drive
4.
Remove the hard drive
5.
Remove the hard drive cage
6.
Remove the heat sink
7.
Disconnect the antenna cable from the connector on the TV tuner module.
8.
Remove the two Torx T5 screws that secure the TV tuner module to the system board.
9.
Lift the card to a 45 degree angle, and then remove the module from the connector by pulling it
away at an angle.
Figure 7-34
To install the TV tuner module, reverse the removal procedure. Make sure the antenna cable is correctly
routed over the speaker and in the clips mounted on the inside chassis wall.
122
Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Removing the Existing Optical Drive on page
(Hard Drive on page
(Hard Drive Cage on page
(Heat sink on page
Removing the TV tuner module
110).
114).
119).
92).
99).
107).
Advertisement
Table of Contents
