Tv Tuner Module - HP Compaq 6005 Pro Maintenance And Service Manual

3. If using a new heat sink, remove the protective covering from the bottom of the heat sink and
place it in position atop the processor.
4. Secure the heat sink to the system board and system board tray with the 4 captive screws and
attach the heat sink control cable and the thermal sensor cable to the system board.
CAUTION:
an X) to evenly seat the heat sink on the processor. This is especially important as the pins on
the socket are very fragile and any damage to them may require replacing the system board.

TV Tuner Module

1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the optical drive
4. Remove the hard drive
5. Remove the hard drive cage
6. Remove the heat sink
7. Disconnect the antenna cable from the connector on the TV tuner module.
8. Remove the two Torx T5 screws that secure the TV tuner module to the system board.
9. Lift the card to a 45 degree angle, and then remove the module from the connector by pulling it
away at an angle.
Figure 6-35
Heat sink retaining screws should be tightened in diagonally opposite pairs (as in
(Removing the Existing Optical Drive on page
(Hard Drive on page
(Hard Drive Cage on page
(Heat sink on page
Removing the TV tuner module
(Preparation for Disassembly on page
(Computer Access Panel on page
51).
55).
60).
31).
40).
48).
TV Tuner Module
61