Automatic Power On - IBM 2196 User Manual

You can specify any of the interrupt requests (IRQs) in the following list as being
exempt from causing the system to enter into or awaken from a power management
state. An I/O device signals the operating system by causing an IRQ to occur. When
the operating system is ready to respond to the request, it interrupts itself and
performs the service.
Choice: Enabled
• IRQ3 (COM2)
• IRQ4 (Available)
• IRQ5 (Audio)
• IRQ6 (Diskette drive)
• IRQ7 (LPT1)
• IRQ8 (RTC Alarm)
• IRQ9 (IRQ2 Redirect)
• IRQ10 (Reserved)
• IRQ11 (Reserved)
• IRQ12 (PS/2 Mouse)
• IRQ13 (Coprocessor)
• IRQ14 (Hard disk)
• IRQ15 (Reserved)

Automatic Power On

Use this setting to define automated methods of waking up the computer:
• wake up when the modem senses an incoming ring
• wake up at a future time
• wake up when the LAN senses an incoming data packet
• wake up when the PCIPME signal is active
• wake up when any key in key board is pressed
You can also define the power button override function. You can make the system
power off instantly or after the power button is pressed for four seconds.
IBM Personal Computer User Guide
6-18