Other Settings In The Configuration/Setup Utility Program; Changing Keyboard Speed; Setting Video Memory Amount; Setting The Startup Sequence - IBM 2196 User Manual

and time, passwords, and any other configuration information you have
changed.
Other settings in the Configuration/Setup Utility
program
The information in this section includes instructions for changing some
other settings in the Configuration/Setup Utility program. (When in the
program, you can select Help to learn more about items within the
program.)

Changing keyboard speed

You can change the speed at which the keyboard responds when you hold
down a key. This setting can be found under Start Options. The default
typematic rate is 30 characters per second (fast rate).

Setting video memory amount

You can select the amount of system memory that is reserved for the
integrated video. To access this setting, select Devices and I/O Ports, then
Video Setup. The amount can be set to either 512 KB or 1 MB. (Operating
systems that use SVGA will allocate additional system memory.)

Setting the startup sequence

Your computer can be started from several devices including the hard disk
drive, diskette drive, CD-ROM drive, or from the network. The startup
program looks for these devices in a selected sequence. You can use
Configuration/Setup Utility program to select the startup sequence.
To set the primary startup sequence:
1. Start the Configuration/Setup Utility program (see "Starting and using
the Configuration/Setup Utility program" on page 3).
2. Select Start Options and press Enter.
3. Select Startup Sequence from the Start Options menu and press Enter.
4. Select First Startup Device and press Enter.
5. Use the arrow keys to make your selection and press Enter.
6. If necessary, repeat the above steps for Second Startup Device, Third
Startup Device, and Fourth Startup Device.
10
Type 6344 User Guide Update