IBM 2196 User Manual page 202

– Disable: In this mode, the monitor is unaffected by the
power-management settings.
IDE Drives: You can use this selection to specify if the IDE drives
should be enabled or disabled when power management options take
affect.
To set power-management features:
1. Start the Configuration/Setup Utility program (see "Starting and using
the Configuration/Setup Utility program" on page 3).
2. Select Power Management and press Enter.
3. Select APM and press Enter.
4. Set Automatic Hardware Power Management to Enabled.
5. Select values for power management (time to low power, system
power, processor speed, display, and time to display off), as desired.
6. Select Low Power Entry Activity Monitor or Low Power Exit Activity
Monitor and press Enter.
7. Set to Enabled or Disabled devices you want to be monitored for
power management.
Note: If all devices are set to disabled, you must restart the computer
to wake the system.
8. Press Esc three times to return to the Configuration/Setup Utility
program menu.
9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
10. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Setting automatic power-on features
You can use the Automatic Power-On features on the Power Management
menu to enable and disable features that automatically turn on your
computer. You must also select the startup sequence you want to use for
the type of power-on event selected.
Wake on LAN: If you have remote-network-management software and
a Wake on LAN supported network adapter, you can use the
IBM-developed Wake on LAN
to Enabled, your computer will turn on when it receives a specific
signal from another computer on your local area network (LAN). For
more information, see the documentation that comes with your
network adapter.
14
Type 6344 User Guide Update
feature. When you set Wake on LAN