Panasonic Lumix DMC-GF1 C Operating Instructions Manual page 18

Preparation
• Optical Image Stabilizer
The Optical Image Stabilizer function is set for activation when the lens is attached to the
camera body.
A lens which supports the stabilizer function is required.
- The 20 mm/F1.7 interchangeable lens supplied with the DMC-GF1C does not support
the stabilizer function.
- The 14-45 mm/F3.5-5.6 interchangeable lens supplied with the DMC-GF1 K supports the
stabilizer function.
Set the [0.1.5.] switch to [ON].
• You can change the Optical Image Stabilizer mode to
[MODE1], [MODE2] or [MODE3] using [STABILIZER] in
the [REC] mode menu. (P117) It is set to [MODE1] at the
time of purchase.
• We recommend setting the [O.I.S.] switch to [OFF] when
using a tripod. If the [O.I.S.] switch is set to [OFF], [II.OFF]
is displayed on the LCD monitor/optional external
viewfinder.
n
Attach the lens cap.
6
Press the lens release button @ while
turning the lens as far as possible in the
direction of the arrow to detach it.
• Always attach the body cap to the camera body so
that dirt or dust does not get inside.
• Attach the lens rear cap so that the lens contact
point does not get scratched.
GNote
• Change lenses where there is not a lot of dirt or dust. Refer to P169 when dirt or dust gets on
the lens.
• When you turn the camera off or carry the camera, attach the lens cap to protect the surface of
the lens.
• Be careful not to lose the lens cap, the lens rear cap and the body cap.
18
VQT2G44