Panasonic Lumix DMC-GF1 C Operating Instructions Manual page 109

Advanced (Recording pictures)
When [AUTO REGISTRATION] is set to [ON] in step
3
of "Change the information for a
registered person"
(P108)
while [FACE RECOG.] in the [REC] Mode menu is set to [ON],
the registration screen will display automatically after taking a picture of a face that has a
high number of appearances.
- Registration screen is displayed after approximately 3 pictures. (It is not counted when Burst
Mode, Auto Bracket, White Balance Bracket, Multi Film Bracket or [AUDIO REC.] is set.)
-It may be extremely hard to recognize only with [AUTO REGISTRATION], so register the face
images with [FACE RECOG.] in the [REG] Mode menu beforehand .
• Registering from the automatic registration screen
1
Press. to select [YES] and then press [MENU/SET].
- If there are no registered persons, proceed to step
3.
- Selection screen is displayed again when [NO] is selected, and
when [YES] is selected with., [AUTO REGISTRATION] will be
set to [OFF].
2
Press
./T
to select [NEW PERSON] or
[ADDITIONAL IMAGE] and then press [MENU/SET].
Item Description of settings
[NEW PERSON]
- A list of registered people is displayed when there are 6 people
already registered. Select the person to be replaced.
To additionally register a face image for a registered person.
Press
./T/... /~
to select the person to whom you wish
[ADDITIONAL IMAGE]
add the picture, and then press [MENU/SET].
- If 3 images have already been registered, the picture
replacement screen will appear. In this case, select the picture
you wish to replace.
3
- After additionally registering or changing a face image, the screen returns automatically to
the recording screen.
Perform the operation in Step
5
and following in "Registering face image of new
person".
eNote
- If the registration screen will not display, it may display easier by recording in the same
conditions or with the same expressions.
-If a face is not recognized even though it is registered, it will make the recognition easier by
registering the person again using the [FACE RECOG.] in the [REG] Mode menu in that
environment.
-If the registration screen is displayed for the person that is already registered, it will make the
recognition easier by additionally registering.
- It may make recognition harder when a picture recorded with flash is registered.
VQT2G44
109