Subaru Forester 2004 Service Manual page 65

ENGINE (DIAGNOSTIC)
Step
2 CHECK POWER SUPPLY TO EACH FUEL
INJECTOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from fuel injector.
3) Turn the ignition switch to ON.
4) Measure the power supply voltage between
fuel injector terminal and engine ground.
Connector & terminal
#1 (E5) No. 2 (+) — Engine ground (
#2 (E16) No. 2 (+) — Engine ground (
#3 (E6) No. 2 (+) — Engine ground (
#4 (E17) No. 2 (+) — Engine ground (
3 CHECK HARNESS BETWEEN ECM AND
FUEL INJECTOR CONNECTOR.
1) Disconnect the connector from ECM.
2) Measure the resistance of harness
between ECM and fuel injector connector.
Connector & terminal
(B136) No. 6 — (E5) No. 1:
(B136) No. 5 — (E16) No. 1:
(B136) No. 4 — (E6) No. 1:
(B136) No. 3 — (E17) No. 1:
4 CHECK HARNESS BETWEEN ECM AND
FUEL INJECTOR CONNECTOR.
Measure the resistance of harness between
ECM and fuel injector connector.
Connector & terminal
(B136) No. 3 — Chassis ground:
(B136) No. 4 — Chassis ground:
(B136) No. 5 — Chassis ground:
(B136) No. 6 — Chassis ground:
5 CHECK EACH FUEL INJECTOR.
1) Turn the ignition switch to OFF.
2) Measure the resistance between each fuel
injector terminals.
Terminals
No. 1 — No. 2:
6 CHECK POOR CONTACT.
Check poor contact in ECM connector.
Diagnostics for Engine Starting Failure
Is the voltage more than 10 V? Go to step 3.
−
):
−
):
−
):
−
):
Is the resistance less than 1
Ω?
Is the resistance less than 1
Ω?
Is the resistance 5 — 20 Ω?
Is there poor contact in ECM
connector?
EN(H4DOTC 2.5)-64
Check
Go to step 4.
Repair ground
short circuit in har-
ness between
ECM and fuel
injector connector.
Go to step 6.
Repair the poor
contact in ECM
connector.
Yes No
Repair the har-
ness and connec-
tor.
NOTE:
In this case repair
the following:
• Open circuit in
harness between
main relay and fuel
injector connector
• Poor contact in
main relay connec-
tor
• Poor contact in
coupling connector
• Poor contact in
fuel injector con-
nector
Repair the har-
ness and connec-
tor.
NOTE:
In this case repair
the following:
• Open circuit in
harness between
ECM and fuel
injector connector
• Poor contact in
coupling connector
Go to step 5.
Replace the faulty
fuel injector.
Inspection using
"General Diagnos-
tic Table". <Ref. to
EN(H4DOTC 2.5)-
258, INSPEC-
TION, General
Diagnostic Table.>