Subaru Forester 2004 Service Manual page 39

ENGINE (DIAGNOSTIC)
5) Connect the Subaru Select Monitor to data link
connector located in the lower portion of the instru-
ment panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and OBD-II general scan tool.
6) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
7) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
8) On the «System Selection Menu» display screen,
select the {Engine} and press the [YES] key.
9) Press the [YES] key after the information of en-
gine type was displayed.
10) On the «Engine Diagnosis» screen, select the
{D Check} and press the [YES] key.
11) When the "Perform D Check?" is shown on the
screen, press the [YES] key.
12) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedure, refer to the "SUB-
ARU SELECT MONITOR OPERATION MANUAL".
• For details concerning DTCs, refer to the List of
Diagnostic Trouble Code (DTC).
<Ref. to EN(H4DOTC 2.5)-65, List of Diagnostic
Trouble Code (DTC).>
• Release the parking brake.
Inspection Mode
• The speed difference between front and rear
wheels may light either the ABS warning light, but this
indicates no malfunctions. When engine control diag-
nosis is finished, perform the ABS memory clearance
procedure of self-diagnosis function. <Ref. to ABS-
23, Clear Memory Mode.>
3. OBD-II GENERAL SCAN TOOL
1) Idle the engine.
2) Connect the test mode connector (A) located at
the lower portion of instrument panel (on the driv-
er's side).
EN-02353
(A)
3) Connect the OBD-II general scan tool to its data
link connector in the lower portion of the instrument
panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and OBD-II general scan tool.
EN-00040
4) Start the engine.
NOTE:
• Ensure the select lever is placed in the "P" range
before starting. (AT model)
• Depress the clutch pedal when starting the en-
gine. (MT model)
5) Using the select lever or shift lever, turn the "P"
position switch and the "N" position switch to ON.
6) Depress the brake pedal to turn the brake switch
ON. (AT model)
7) Keep the engine speed in the 2,500 — 3,000
rpm range for 40 seconds.
8) Place the select lever or shift lever in the "D"
range (AT model) or "1st" gear (MT model) and
drive the vehicle at 5 to 10 km/h (3 to 6 MPH).
EN(H4DOTC 2.5)-38
(A)
EN-00333
EN-02353