Fireplace Assembly - Dimplex DF2690 Owner's Manual

Fireplace Installation

Fireplace Assembly

Depending on the unit, the front
glass will come packaged sepa-
rately or installed in the firebox.
1. Remove fireplace and glass
(if not already installed) care-
fully from the carton, discard
the plastic bag and foam
packaging.
2. Remove the right hand side
trim by removing four Phillips
screws at the side of the fire-
place. (Figure 3)
3. Remove the front glass, if
necessary
4. Remove the foam block from
within the fireplace (Figure 2).
5. Using side cutters or scissors,
Figure 2
Cable
Ties
8
Figure 3
Foam
Block
cut and remove the two cable
ties as shown in Figure 2 and
remove the cardboard that
protects the log set.
6. Place the Front Glass onto
the track of the fireplace (Fig-
ure 3) and slide it along the
front until it reaches the far
left of the unit.
7. Re-attach the right hand trim
piece using the four Philips
screws from step 4.
Mantel Installation
Install the fireplace assembly into
the mantel (refer to mantel as-
sembly instructions).
!
IMPORTANT: If not using a
Dimplex mantel, the fireplace
Track
Front
Glass
Trim
www.dimplex.com