Table of Contents
Advertisement
The product must not bear the weight of the finished wall located above it. Consider the
use of a lintel for appropriate support.
2.Using any combination of the three fixing methods (Fig. 13 a,b,c), fix the product to its
supporting structure.
3.Build the finished wall up against the appliance using the glass trims as a guide.
The finished wall should be built in a way that allows the power supply to be accessible after
installation, the use of an accessible fused isolation switch should be incorparated into
the structure where the plug is located within the structure. Please consult a professional
installer for advise on this.
It is recommended to leave 150mm of clearance area directly above the product for ventilation
purposes. (Fig. 12) This clearance area can be located behind the finished wall surface.
The product should not be sealed in place with silicone or adhesive as this can restrict airflow.
Step 3: Fuelbed Assembly
A range of fuel bed material has been provided for you to choose your desired look.
A set of high-quality ceramic logs enhance the effect of this fire. Please take great care when
handling these logs to ensure they do not get dropped or rub against each other, as they are
easily marked. The following fuel bed media is included
•
Ceramic Logs
•
Ash Dust
•
Crystal pieces
We have taken great care to create what we feel is the most authentic fuel bed, please follow the
steps below for more information. Please note: A mix and match of fuelbed media can also be
done to create unique fuel bed assembly.
1. Remove front trim on unit. (Fig. 2)
2. Remove Front Glass from product and store in a safe place. (Fig. 6) (A suction cup is
provided to help remove/replace the front glass.)
3. For a contemporary setup (Fig.14), place crystals on fuel bed, covering the top surface of
the fuel bed. These will provide a glowing embers effect, when the flame effect is operating.
4. For a traditional look, arrange the logs on top of the fuel bed, to your preference. Please
follow the steps at the end of this document which provide a visual representation for log
arrangement. This is a proposal on how to arrange the logs, it is however open to your
own preference and interpertaion to achieve a look you prefer.
5. Ash dust is also supplied for this setup. Sprinkle this across the fuel bed to produce a
realistic log burning effect. (Note: Please place the ash dust carefully around the logs to
prevent you from seeing the fuel bed under lights in the reflective inner screen to allow you
have a realistic fuel bed As per Fig 18).
6. Reverse steps 1 and 2 to re-assemble product.
An Authentic Logset
for part numbers.
can be purchased seperatly, see table across
5
Authentic Log
Model
Part Number
VVT75
03/24180/0
VVT100
03/24181/0
VVT150
03/24183/0
Advertisement
Table of Contents
