Dimplex DF2690 Owner's Manual page 13

Operation
hundreds of independent frequen-
cies to prevent interference with
other units.
!
NOTE: Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover.
Remote Control Initialization/
Reprogramming
This procedure is required every
time there is a loss of power to
the remote control in the fire-
place. (i.e. power failure, breaker
tripped, On/Off switch is turned
off.)
1. Ensure that power is supplied
through main service panel.
2. Locate manual controls.
3. Activate On/Off switch. (Fig-
ure 5A)
4. Press and hold the 3-Position
Switch in the "I" position for
5-10 seconds until the second
indicator light begins to flash.
(Figure 5E)
5. Press the ON button located
on the remote control. (Figure
6)
This will synchronize the remote
control and receiver.
Remote Control Usage
The remote control operates the
fireplace levels sequentially. The
level is increased every time the
"ON" button on the remote control
is pressed. The fireplace can be
turned off at any point by pressing
the "OFF" button on the remote
control.
Battery Replacement (Figure 6)
To replace battery:
1. Slide battery cover open on
the remote control.
2. Install one 12-volt (A23) bat-
tery in the battery holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
13