Fireplace Assembly - Dimplex ELECTRALOG DF203A Owner's Manual

Fireplace Installation
! NOTE: Although the wood
frame can be discarded, the
screws and washers should be
kept to attach the firebox to a
Dimplex mantel or surround (if
applicable).

Fireplace Assembly

The only assembly required is to
place the front glass assembly
onto the fireplace and install
hardware to keep it in place.
1. With the fireplace laying on
a flat and level surface from
step 3 of the unpacking
Instructions, turn the glass
retaining brackets into a
vertical position.
2. Place the bottom of the glass
panel onto the glass support
track located just in front of
and below the ember bed
(Figure 4A).
Figure 4
Bottom of
Fireplace
8
3. As shown in Figure 4B, lay
the top of the glass panel
into the corresponding glass
support track at the top of the
viewable fireplace.
4. Turn the glass retaining
brackets back into the original
position and secure them
with the supplied screws (1
per side of glass) as shown
in Figure 5. refer to Figure 6
for an assembled view.
5. using a flat head or Philips
screwdriver, fasten screws
through chassis bracket and
into glass retaining bracket.
6. Repeat for other upper
corner.
Fireplace Installation
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
A
B
Glass Retaining
Bracket
Top of
Fireplace
www.dimplex.com