Dimplex DF2690 Owner's Manual page 15

Maintenance
1. Slide fireplace out of mantel.
2. Lay unit on it's back for safe
removal of front glass.
3. Remove four Phillips screws
from the right side of trim.
4. Slide glass to right side of
fireplace to remove (Figure
7).
5. Pull the front edge of the
plastic ember bed or plastic
grate up and forward until the
rear tab releases from the
ledge located at the bottom
of the partially reflective glass
(Figure 8).
6. Remove flicker rod by slid-
ing flicker rod to the left away
from the flicker motor and
lifting out.
7. Remove light bracket for
easier access to light bulbs.
!
IMPORTANT: Only handle the
log set by the ember bed.
!
NOTE: Log set fits tightly into
firebox, some force may be nec-
essary to remove.
8. Set log set in front of fire-
place.
9. Unscrew bulbs counter clock-
wise.
10. Insert new bulbs.
11. Replace the log set by insert-
ing the front edge of the
fireplace and push down on
the rear edge of the ember
bed until it snaps into place
(Figure 8).
12. Lay unit on it's back and slide
front glass back into position
and attach trim.
!
NOTE: Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
Upper Light Bulb Requirements
Quantity of two clear chandelier
or candelabra bulbs with an E-12
(small) socket base, 15 Watt rat-
ing. Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
CAUTION:
minutes for the light bulbs to cool
before touching them to avoid ac-
cidental burning of the skin.
1. Slide fireplace out of mantel.
2. Lay unit on it's back for safe
removal of front glass.
3. Remove four Phillips screws
from right side of trim.
4. Remove trim.
5. Slide glass to the right side of
Allow at least five
15