Remote Control - Dimplex DF2690 Owner's Manual

Operation
not change just the amount of
heat being emitted.
F. 3-Position Switch
Pressing the switch up "I" toggles
sequentially through the three lev-
els of the fireplace.
Level 1: The flame effect is
turned on and the first red indica-
tor light flashes momentarily.
Level 2: The flame effect remains
on, the heater is activated to the
low heat setting, and the first and
second red indicator lights flash
momentarily.
Level 3: The flame effect remains
on, the heater is set to the high
heat setting, and all three red indi-
cators flash momentarily.
Pressing the switch down "II" will
turn the unit Off.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting five
minutes before switching the unit
back on.
If operating the unit with a remote
control, the remote may require
12
re-initializing after turning the
power off.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dim-
plex North America Limited at
1-888-346-7539 for technical
support. Please have your
model and serial number
ready when calling.

Remote Control

The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one of
Figure 6
On
Button
Off
Button
Plastic
strip
Battery
cover
www.dimplex.com