Install Drive Wheels; Check Tire Pressure; Install Seat Retaining Rod; Install Motion Control Levers - Exmark Lazer Z HP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

3.3 INSTALL DRIVE WHEELS

3.3.1

3.4 CHECK TIRE PRESSURE.

3.4.1

3.5 INSTALL SEAT RETAINING ROD.

3.5.1

3.6 INSTALL MOTION CONTROL LEVERS.

3.6.1
Mount drive wheels with the valve stem to the outside of the unit. Secure using
four (4) 1/2-20 wheel nuts (installed on studs in hubs) for each wheel. Torque
to 95 ft-lbs (128 NžM).
Check tire pressure in caster and drive tires. Proper inflation pressure for all
four (4) tires is 13 psi (90 kPa). Adjust if necessary.
Tilt seat up. Remove 5/16" nyloc nut from bolt attaching seat retaining rod to
seat frame. Remove ignition keys attached to bolt. Remove retaining rod from
seat and insert the "L" shaped end of the rod into the hole directly above the
left-side hydraulic pump (the "L" must be positioned pointing up). Position the
seat retaining rod to the outside of the mounting tab on the seat frame and
secure with 5/16" x 1" bolt and nyloc nut. Tighten until snug, then loosen just
enough so the rod pivots freely.
Loosen and remove the two (2) 3/8" x 1" bolts and spring disc washers which
attach the motion control levers to the control arm shafts for shipping and the
two (2) 3/8" x 1" bolts and spring disc washers which are screwed into the
control arm shafts.
a) Install the left motion control lever onto the control arm shaft (See Fig 1)
on the left side of the console. Place the lever (with the mounting plate
towards the rear) on the outside of the control arm shaft and secure with
the bolts and washers. Position the lever so the bolts are in the center of
the slots on the lever mounting plate and tighten until snug. Repeat on
opposite side of unit.
NOTE: There are two lever height options available. Place the levers in
the top two holes to increase height of the levers, or in the bottom two
holes to decrease the height of the levers.
If the levers do not align with each other, when in the neutral position,
(See Fig 2) loosen the hardware and make the appropriate adjustment by
sliding/tilting the lever(s) forward or backward until properly aligned and
tighten hardware.
MOTION
CONTROL
LEVER
FIG. 1
CONTROL ARM SHAFT
www.mymowerparts.com
.
MOUNT PLATE TO
THE REAR & OUTSIDE
OF ARM SHAFT
- 13 -
LEVERS IN
ALIGNMENT
FIG. 2
LEVER ALIGNMENT