Exmark Lazer Z HP Operator's Manual page 28

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.9 Check Spark Arrester
5.1.10
5.1.11
Service Interval: 50 hours
POTENTIAL HAZARD
♦ Hot exhaust system components may ignite gasoline vapors
even after the engine is stopped.
♦ Hot particles exhausted during engine operation may ignite
flammable materials.
WHAT CAN HAPPEN
♦ Fire may result in personal injury or property damage.
HOW TO AVOID THE HAZARD
♦ Do NOT refuel or run engine unless spark arrester is installed.
1. Shut off engine, remove key, and wait for all moving parts to stop.
2. Wait for muffler to cool.
3. If any breaks in the screen or welds are observed, replace arrester.
4. If plugging of the screen is observed, remove arrester and shake loose
particles out of the arrester and clean screen with a wire brush (soak in solvent
if necessary). Re-install arrester on exhaust outlet.
Change engine oil:
Service Interval: 100 hrs.
NOTE: Change oil and filter after first five(5) hrs. of operation
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Drain oil while engine is warm from operation.
c) Oil drain valve is located on left hand side of Kohler engine and right
hand side of Kawasaki engine. Place pan under machine to catch oil and
open valve with 10 mm wrench. Allow oil to drain then close valve.
d) Replace the oil filter every other oil change. Clean around oil filter and
unscrew filter to remove. Before reinstalling new filter, apply a thin
coating of oil on the surface of the rubber seal. Turn filter clockwise until
rubber seal contacts the filter adapter then tighten filter an additional 2/3
to 3/4 turn.
e) Clean around oil fill cap and remove cap. Fill to specified capacity and
replace cap. Use oil recommended in engine owner's manual. DO NOT
overfill.
f) Start the engine and check for leaks.
Check hydraulic oil level:
Service Interval: 40 hr.
a) Stop engine and wait for all moving parts to stop.
b) Clean area around hydraulic reservoir cap and remove cap.
c) Check hydraulic reservoir and if necessary fill the reservoir to the
appropriate level with Mobil 1 15W-50 synthetic motor oil. Replace
hydraulic reservoir cap and tighten until snug. Do not overtighten.
NOTE: The baffle is labeled "HOT" and "COLD". The oil level varies with
the temperature of the oil. The "HOT" level shows the level of oil when it is
at 225°F (107°C). The "COLD" level shows the level of the oil when it is at
75°F (24°C). Fill to the appropriate level depending upon the temperature
www.mymowerparts.com
WARNING
- 23 -