Adjustments - Exmark Lazer Z HP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

5.2 ADJUSTMENTS

5.2.1
5.2.2
IMPORTANT: Disengage PTO, shut off engine, wait for all moving parts
to stop, and remove key before servicing, cleaning or making
adjustments.
Cutting Height Adjustment.
a) Stop machine and move drive levers out to neutral lock position.
b) Disengage PTO.
c) Raise the deck lever to the transport position (also the 4.5" cutting height
position). See Fig 5.
NOTE: When changing cutting height positions, always come to a
complete stop and disengage the PTO.
CUTTING HEIGHT POSITION
d) Insert height adjustment pin into hole corresponding to desired cutting
height and install hairpin cotter. See decal on deck lift plate.
e) Move lever out of transport (or 4.5" cutting height) position and down onto
height adjustment pin to mow at selected height.
f) To transport, move lever back up to transport (or 4.5" cutting height) position.
g) Adjust anti-scalp rollers for Normal Operating Conditions. Stop engine,
wait for all moving parts to stop, and remove key. Place rollers in one of
the positions shown in Fig. 6. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
For Maximum Deck Flotation, place rollers one hole position lower.
Rollers should maintain 1/4 in. (6.4 mm) minimum clearance to ground. Do
Not adjust rollers to support the deck. Be sure bolt is tightened properly or
loss of anti-scalp roller may result.
ANTI-SCALP ROLLER ADJUSTMENT
Deck Leveling:
a) Position mower on a flat surface.
b) Stop engine, wait for all moving parts to stop, and remove key.
c) Check tire pressure of all four (4) tires. If needed, adjust to 13 psi (90 kPa).
www.mymowerparts.com
FIG. 5
FIG. 6
- 28 -