Exmark Lazer Z HP Operator's Manual page 36

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.2.9
5.2.10
5.2.11
b) Tension in throttle lever can be adjusted by adjusting the tightness of the
lever pivot bolt, which is located under the console. See Fig. 9.
THROTTLE TENSION
Electric Clutch Adjustment:
No adjustment necessary.
Reverse Indicator Adjustment:
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tilt seat forward.
c) Begin with either the left or right motion control lever. Move lever to the
neutral position and pull lever back until the clevis pin (on arm below pivot
shaft) contacts the end of the slot (just beginning to put pressure on
spring), See Fig 10.
d) Check where lever is relative to notch in console (should be centered
allowing lever to pivot outward to the neutral lock position).
e) If adjustment is needed, loosen the nut against the yoke and while
applying slight rearward pressure on the motion control lever, turn the
head of the adjustment bolt in the appropriate direction until lever is
centered (keeping rearward pressure on the lever will keep the pin at the
end of the slot and allow the adjustment bolt to move the lever to the
appropriate position). Tighten lock nut.
f) Repeat on opposite side of unit.
Motion control linkage adjustment.
POTENTIAL HAZARD
♦ Engine must be running and drive wheels must be
turning so motion control adjustment can be performed.
WHAT CAN HAPPEN
♦ Contact with moving parts or hot surfaces may cause
personal injury.
HOW TO AVOID THE HAZARD
♦ Keep fingers, hands, and clothing clear of rotating
components and hot surfaces.
www.mymowerparts.com
Fig. 9
WARNING
- 31 -