Install Drive Wheels; Check Tire Pressure; Install Seat Retaining Rod (Standard Seat) Or Seat (Suspension Seat); Connect Right Front Deck Lift Arm - Exmark Lazer Z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

3.3 INSTALL DRIVE WHEELS

3.3.1

3.4 CHECK TIRE PRESSURE.

3.4.1

3.5 INSTALL SEAT RETAINING ROD (Standard Seat) or SEAT (Suspension Seat)

3.5.1

3.6 CONNECT RIGHT FRONT DECK LIFT ARM

3.7 INSTALL CANISTER AIR CLEANER.
Mount drive wheels with the valve stem to the outside of the unit. Secure using
four (4) 1/2-20 wheel nuts (installed on studs in hubs) for each wheel. Torque to
95 ft-lbs (128 N M).
Check tire pressure in caster and drive tires. Proper inflation pressure for all four
(4) tires is 13 psi (90 kPa). Adjust if necessary.
For all units with a standard seat: Tilt seat up. Remove 5/16" nyloc nut from bolt
attaching seat retaining rod to seat frame. Remove retaining rod from seat and
insert the "L" shaped end of the rod into the hole directly above the left-side
hydraulic pump mounting hardware (the "L" must be positioned to the right).
Position the seat retaining rod to the outside of the mounting tab on the seat
frame and secure with 5/16"x 1" bolt and nut. Tighten until snug, then loosen just
enough so the rod pivots freely.
For all units with a suspension seat: The seat base frame with adjustable tracks
and seat retaining rod are already attached to the unit. Remove the
suspension seat from front of crate and discard the hardware. Position the seat
on the studs in the adjustable tracks; be sure the left and right tracks are aligned
(See Figure 1). Loosen the vinyl curtain frame at the rear by pushing down and
ahead out of the hole. Secure the seat with four 5/16 whizlock nuts. Reattach
the vinyl curtain frame. Connect the terminal at the end of the wire tied to the
seat frame to the switch in the bottom of the seat.
For units with standard seat only:
a) Remove e-ring and washer from the front swivel in the right deck lift spring
assembly.
b) Insert the swivel through the hole in the right front lift weldment (it may be
necessary to lift the right front corner of the mower deck) and reinstall the washer
and e-ring.
For Kohler units only:
a) Remove air cleaner (with bracket attached) from crate. Keep air cleaner and
mounting bracket together.
b) Remove the top two valve cover mounting screws from both left and right side
engine valve covers. Keep screws for re-attaching air cleaner.
c) Position the air cleaner assembly over the engine, aligning air cleaner bracket
holes with top holes in the valve covers. Reinstall valve cover screws through air
cleaner bracket and torque to 70 in. lb. (4.9 N-m).
d) Remove plastic plugs from air intake elbow on engine and air cleaner hose. Adjust
the air cleaner and hose as required and connect intake hose to air cleaner outlet.
Position and tighten the two hose clamps to secure the hose connections.
e) Secure air cleaner by tightening the tensioning bolt and spring assembly until
ends of clamp are approximately ½" (12.7 mm) apart.
www.mymowerparts.com
.
- 16 -