Exmark Lazer Z HP Operator's Manual page 31

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
5.1.16
5.1.17
5.1.18
5.1.19
5.1.20
5.1.21
5.1.22
5.1.23
Lubricate seat switch actuator:
Service Interval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tilt seat up.
c) Lubricate switch actuator rod with spray type lubricant or light oil.
Lubricate brake handle pivot:
Service Interval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate bronze bushings on brake handle pivot with a spray type
lubricant or light oil.
Lubricate brake rod bushings:
Service Interval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tilt seat up.
c) Lubricate bronze bushings on each end of brake rod shafts with a spray
type lubricant or a light oil. One shaft is located under the console. The
other is below and behind the seat.
Lubricate motion control bronze bushings:
Service Interval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tilt seat up.
c) Lubricate bronze bushings on flange bearings securing the motion control
arm shafts with a light oil or a spray type lubricant.
Remove engine shrouds and clean cooling fins:
Service Interval: 80 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Remove cooling shroud clean-out covers (Kohler) or cooling shrouds
(Kawasaki Air-cooled) from engine and clean cooling fins. Also clean
dust, dirt and oil from external surfaces of engine which can cause
improper cooling.
c) Make sure cooling shroud clean-out covers or cooling shrouds are
reinstalled. Operating the engine without cooling shroud clean-out covers
or cooling shrouds will cause engine damage due to overheating.
Check spark plugs:
Service Interval: 160 hrs.
a) Remove spark plugs, check condition and reset gaps, or replace with
new plugs. See Engine Owners Manual.
Change fuel filter:
Service Interval: As Required
a) A fuel filter is installed between the fuel tanks and the engine. Replace
when necessary.
For Kohler engines use Kohler P/N 2405002.
For Kawasaki engines use Kawasaki P/N 49019-7001
Change hydraulic system filter:
Service Interval: After First 250 hrs.
NOTE: Use only Exmark Part No. 1-513211 for Summer use above 32° F or
Part No. 1-523541 for Winter use below 32° F.
www.mymowerparts.com
Then yearly thereafter
- 26 -