Planet WNRT-627 User Manual page 82

Incoming Protocol
Status
To add a new rule, follow the steps below.
Step 1. Click the Add New... button, the next screen will pop up as shown in
Step 2. Select a common application from the Common Applications drop-down list, then the
Trigger Port field and the Incoming Ports field will be automatically filled. If the Common
Applications do not have the application you need, enter the Trigger Port and the
Incoming Ports manually.
Step 3. Select the protocol used for Trigger Port from the Trigger Protocol drop-down list, either
TCP, UDP, or All.
Step 4. Select the protocol used for Incoming Ports from the Incoming Protocol drop-down list,
either TCP or UDP, or All.
Step 5. Select Enable in Status field.
Step 6. Click the Save button to save the new rule.
outgoing request. A response using one of these ports will be forwarded to the
PC that triggered this rule. You can input at most 5 groups of ports (or port
section). Every group of ports must be set apart with ",". For example,
2000-2038, 2050-2051, 2085, 3010-3030.
The protocol used for Incoming Ports Range, either TCP or UDP, or ALL
(all protocols supported by the Router).
The status of this entry either Enabled or Disabled.
Table 5-25
-82-
User's Manual of WNRT-627
Figure 5-40.