Horizon Fitness EX-69 Owner's Manual page 14

ASSEMBLY STEP 3
EX-79 SHOWN
ALL
MODELS
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
14
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
AND WASHERS
MAIN FRAME
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
WAVY WASHER (L)
22.5 mm
Qty: 2
Open HARDWARE FOR STEP 3.
A
Carefully pull the CONSOLE CABLE through
B
the CONSOLE MAST using the twist tie located
inside the CONSOLE MAST.
Attach CONSOLE MAST to MAIN FRAME
C
using PRE-INSTALLED BOLTS AND
WASHERS.
Slide WAVY WASHER (L) over CRANK
D
followed by PEDAL ARM as shown. Rest
PEDAL ARM WHEEL on GUIDE RAIL.
Attach the PEDAL ARM to the CRANK using
E
1 FLAT WASHER (K), 1 SPRING WASHER (B)
WAVY WASHER (L)
and 1 BOLT (M).
FLAT WASHER (K)
SPRING WASHER (B)
Repeat steps D–E on the opposite side of the
BOLT (M) F
elliptical.
HARDWARE FOR STEP 3:
BOLT (M) SPRING WASHER (B)
20 mm 15 mm
Qty: 2 Qty: 2
FLAT WASHER (K)
20 mm
Qty: 2