Using The Projection Login Code - BenQ SH915 User Manual

iii. When you install the Q Presenter, the program will automatically identify the
language of your computer's operating system and install the same language as
your operating system. If your language isn't included, the system will keep
English as the default setting.
iv. You can select whether to allow notification message popup.
v. Once you set to activate 1:N display, 1PC/NB can display up to 8 projectors at
the same time.
vi. Once set, press Apply to save the changes.
vii. You can select Video or Graphic display mode. Graphic Mode: worse image
quality but faster tramsmission speed. Video Mode: better image quality but
slower transmission speed. However, the actual transmission performance was
determined by the status of network usage at that time.
viii. You can select whether to automatically open the Q Presenter application when
the computer is powered on.
ix. Once set, press Apply to save the changes.
x. You can link to the BenQ remote network operation page on page 50.

Using the Projection Login Code

This function is designed to ensure network display through the correct projector. To
toggle this function:
1. Go to the System Setup: Advanced > Network Settings menu after opening
the OSD menu system. Press MODE/ENTER.
2. Press ▼ to select Projection Login Code and press ◄/► to select On or Off.
When this function is on, the
projector generates a random 4-digit
code in the upper right corner when
you switch the source to Network
Display. You need to key in this 4-digit
code in the Q Presenter when
connecting to the projector.
Operation
vii
viii
ix
x
61