And Placing The Range - Thermador PD304 Installation Instructions Manual

Step 3: Unpacking, Moving and Placing the Range
• Due to the weight, a dolly with soft wheels
should be used to move this unit. The weight
must be supported uniformly across the bottom
(See Fig. 6).
• After transporting the professional range by
dolly close to its final location, the range can be
tipped back and supported on the rear legs
while the dolly is carefully removed. THE FLOOR
UNDER THE LEGS SHOULD BE PROTECTED
(WOOD STRIPS, CARPET, PANELING, ETC.)
BEFORE PUSHING THE UNIT INTO POSI-
TION. The anti-tip device must be installed
(STEP 4), gas and electric connections should be
made (STEPS 5 and 6), and the backguard in-
stalled (STEP 7) before the range is placed in its
final position.
For proper performance the professional
•
range must be level. (It is very important for
all products that have the griddle feature).
The range is leveled by adjusting the legs
with a wrench. Replace the kick panel and
install oven door. It is important that the
two (2) screws retaining the kick panel are
secure to prevent accidental access to hot
surfaces.
• Ensure that the burner caps are correctly
seated on the burner bases of the range.
Fig. 6- Dolly Positioning
Page 11