Important Installation Information - Thermador PD304 Installation Instructions Manual

This appliance has been tested in accordance with
ANSI Z21.1 Current Issue Standard for Household
Cooking Appliances (USA).
It is strongly recommended that this appliance be
installed in conjunction with a suitable overhead
vent hood. (See Step 1 for Ventilation Require-
ments.) Due to the high heat capability of this unit,
particular attention should be paid to the hood and
duct work installation to assure it meets local build-
ing codes.
CAUTION
To eliminate risk of burns or fire caused by
reaching over heated surface units, cabinet
storage located above the surface units should
be avoided.
Check local building codes for the proper method of
appliance installation. Local codes vary. Installation, elec-
trical connections and grounding must comply with all
applicable codes. In the absence of local codes the
appliance should be installed in accordance with the
National Fuel Gas Code ANSI Z223.1/NFPA54-current
Issue and National Electrical Code ANSI/NFPA70-current
Iissue.

Important Installation Information

(1) When connecting the unit to propane gas,
make certain the propane gas tank is
equipped with its own high pressure regu-
lator in addition to the pressure regulator
supplied with this unit. The maximum gas
pressure to this appliance is not to exceed
14.0 inches (37mb) water column from the
propane gas tank regulator.
(2) This unit is designed as a cooking appli-
ance. Based on safety considerations never
use it for warming or heating a room
This appliance is equipped with an intermittent/
interrupted ignition device that cycles the two far left
surface burners on and off when in the ExtraLow
setting.
Page 3
CAUTION:
.
®