ELECTRICAL SUPPLY, DUAL FUEL RANGES
Installation of Dual Fuel ranges must
be planned so that the rough-in of the
junction box for the receptacle or con-
duit connection will allow maximum
clearance to the rear of the unit.
When the power supply cord (not sup-
plied) or conduit is connected to the
mating receptacle or junction box
Power Cord & Receptacle
Step 2: Cabinet Preparation
cover, the combined plug/receptacle
or junction box cover/conduit con-
nector should protrude no more than
2-1/4 inches from the rear wall. See
Figure 3B.
This is especially critical if the junction
box in the wall will be directly behind
the junction box on the unit when the
FIG. 3B WALL CONNECTION
Page 9
unit is installed. Refer to Figure 9 on
Page 16 for location of junction box
on unit. To minimize binding when
the unit is connected to the recep-
tacle or junction box, orient the re-
ceptacle or conduit connector, and
slide back into position.
Junction Box & Conduit