Installing A Headset With Feature Control Switch; Handling Calls With A Headset (With Feature Control Switch) - Mitel 5224 Manual

Installing a Headset with Feature Control Switch

IMPORTANT NOTE: Mitel Networks Headsets with Feature Control must be
installed in the dedicated headset jack (the jack nearest the front of the set).
Installation will disable your handset microphone. Disconnecting the headset at
the jack or at the quick-disconnect plug restores handset operation.
To install the headset for your use
1. When the telephone is not in use, lift the handset from the cradle and
carefully turn the set upside down.
2. Plug the headset cord into the headset jack (the jack nearest the front
of the set).
3. Set the telephone upright and return the handset to the cradle.
4. Press the Headset Feature Key.
To return to handset operation
1. When the telephone is not in use, lift the handset from the cradle and
carefully turn the set upside down.
2. Unplug the headset cord where it connects to the telephone.
3. Set the telephone upright and return the handset to the cradle.
4. Press the Headset Feature Key.
5. Store your headset in a safe place.

Handling Calls with a Headset (with Feature Control Switch):

To answer a call (when Auto Answer is disabled):
•
Press the flashing Line Select key
-or-
Quickly press and release the Feature Control Switch.
To mute the headset microphone:
•
Press and hold the Feature Control Switch.
To hang up:
•
Press the Cancel Function Key
-or-
Quickly press and release the Feature Control Switch.
16