Table of Contents
Advertisement
Troubleshooting Guide
this issue involves lowering the Black Bar Sensor Sensitivity to a level that
will allow the sensor to detect the black bars between labels.
1. Press the
2. When Interface Status Off-Line is displayed, press the
will take you the to the Print Parameters menu.
Press the
3. Press the
4. Press the
Press the
5. Press the
6. Press the
additional time to lower the value by an additional 10%. If however, the
Media Feed Fault message still occurs, press the
the procedure again.
If this procedure fails to produce a working sensor sensitivity that stops the
Media Feed Fault messages contact qualified service personnel.
ONLINE
key. This takes you to the off-line menu.
PAUSE
ITEM
key until the Bar Sense parameter displayed.
FEED
key to lower the value by 10%.
CANCEL
ONLINE
key. The display will read ENTER to save new defaults.
PAUSE
ENTER
key to save these values.
PRINT
ONLINE
key. This will take the printer off-line.
PAUSE
ITEM
key. If the label feeds correctly repeat the procedure one
FEED
60
MENU
key. This
key and repeat
CANCEL
Advertisement
Table of Contents
