Table of Contents
Advertisement
Operator Panel Reference
System Params.
Parameter
Units
Media Alignment
ENTER to recall
defaults
ENTER to Select
Diagnostics
Firmware Part No.
XXXXXXYY
Hex Dump Mode
Settings Label
Press Enter Key
Values
Inches or
Selects the units for
Millimeters
parameter values
Automatic or
Automatic: Printer will align
the label prior to printing first
Manual
label
Manual: Operator is
responsible for aligning label
start position
-
Pressing the
cause parameter values to
reset to default values
-
Pressing the
bring the printer into the
sensor diagnostic mode. (see
Verifying the Sensor
Operation in the
Troubleshooting Guide)
-
The firmware part number
and revision are displayed
ON or OFF
Printer will enter into Hex
Dump mode after the next
Power Cycle. (see Hex Dump
Mode in the
Troubleshooting Guide)
-
Pressing the
print the current parameter
value settings.
44
Description
ENTER
key will
PRINT
ENTER
key will
PRINT
ENTER
key will
PRINT
Advertisement
Table of Contents
