AMT Datasouth Codewriter 4500 Series Operator's Manual page 39

Amt datasouth printers operator's manual
Table of Contents

Advertisement

Programming the Label Dimensions
The following procedure guides the operator through programming the label
dimensions into the printer via the Operator Panel.
ONLINE
1. Press the
key. This takes you to the off-line menu.
PAUSE
2. When Interface Status Off-Line is displayed, press the
will take you the to the listing of sub-menus.
MENU
3. Press the
key until the Label Parameters option is displayed.
ITEM
4. Press the
key until the Label Width parameter is displayed. Use the
FEED
or
keys to set the value to the label's width.
CANCEL
NOTE: When changing values using the
single key press will change the value by one unit. If the key is
pressed and held in, the value will change by 10 units.
ITEM
5. Press the
key again. Label Length is the next parameter. Use the
FEED
or
keys to set the value to the label's length. Refer to the
CANCEL
Figure corresponding to the label type for the correct Label Length. For
Continuous media, enter the desired length.
ITEM
key again. Label Gap is the next parameter. Use the
6. Press the
FEED
or
keys to set the value to the Label Gap length. If using black
CANCEL
bar labels, set Label Gap to 0.01. If using continuous labels set the value
to 0.00.
ONLINE
7. Press the
key. If any parameters were changed, the display will read
PAUSE
ENTER to save new defaults. Press the
The display will then read Interface Status Online.
8. To verify the settings are correct, press the
Status Off-Line displayed, press the
cause the labels to feed out of the printer. If the labels feed correctly,
stopping at the same point each time, put the printer back on-line by
ENTER
key to save these values.
PRINT
ONLINE
key. With the Interface
PAUSE
ITEM
key a couple times. This will
FEED
29
Media Settings
MENU
key. This
or
keys, a
CANCEL

Advertisement

Table of Contents
loading

Table of Contents

Save Article as PDF