AMT Datasouth Codewriter 4500 Series Operator's Manual page 22

Quick Start Guide
Set Label Parameters
1. Press the
2. When Interface Status Off-Line is displayed, press the
will display the sub-menus.
3. Press the
4. Press the
options for this parameter are Direct Thermal and Thermal Trans. Press
the or
installed select Thermal Trans. Otherwise select Direct Thermal.
Complete the selection process by pressing the
will appear in front of the selected option to indicate the value has been
set.
5. Press the
Use the
NOTE: When changing values using the
single key press will change the value by one unit. If the key is
pressed and held in, the value will change by 10 units.
6. Press the
or
CANCEL
not include the Label Gap (see Figure 6). For label length information for
other media types see this manual's Media Settings section.
7. Press the
or
CANCEL
bar labels, set Label Gap to 0.01. If using continuous labels set the value
to 0.00.
ONLINE
key. This takes you to the off-line menu.
PAUSE
MENU
key until the Label Parameters option is displayed.
ITEM
key. Media Type is the first parameter displayed. The two
FEED
key to change the option. If the printer has a ribbon
CANCEL
ITEM
key again. Label Width is the next parameter displayed.
FEED
or keys to set the value to the label's width.
CANCEL
ITEM
key again. Label Length is the next parameter. Use the
FEED
keys to set the value to the label's length. This value does
ITEM
key again. Label Gap is the next parameter. Use the
FEED
keys to set the value to the Label Gap length. If using black
12
MENU
key. This
ENTER
key. An asterisk (*)
PRINT
or keys, a
CANCEL