Table of Contents
Advertisement
Adjusting the Black Bar Sensor Sensitivity
The printer uses the Black Bar Sensor system to detect black bar on the back
of label stock. Setting the Label Gap parameter value to Black Bar (0.01
inches) causes the printer to use this method. Verify that the Label Gap is set
to this value prior to continuing with this procedure (see Media Settings
section, Programming the Label Dimensions). Follow the procedure
based on the type of problem reported by the printer.
Printer is Displaying "Media Out" Message
The printer displays this message when the Black Bar Sensor sensitivity level
is less than required. The Black Bar Sensor is not receiving light reflecting
from the back of the label stock, indicating a label with inferior reflective
qualities. Resolving this issue involves raising the Black Bar Sensor
Sensitivity to a level that will allow the sensor to detect back of the label
stock.
ONLINE
1. Press the
key. This takes you to the off-line menu.
PAUSE
2. When Interface Status Off-Line is displayed, press the
will take you the to the Print Parameters menu.
ITEM
Press the
key until the Bar Sense parameter displayed.
FEED
3. Press the
key to raise the value by 10%.
ONLINE
4. Press the
key. The display will read ENTER to save new defaults.
PAUSE
ENTER
Press the
key to save these values.
PRINT
ONLINE
5. Press the
key. This will take the printer off-line.
PAUSE
ITEM
6. Press the
key. If the label feeds correctly repeat the procedure one
FEED
additional time to raise the value by an additional 10%. If however, the
Media Out message still occurs, press the
procedure again.
If this procedure fails to produce a working sensor sensitivity that stops the
Media Out messages contact qualified service personnel.
Printer is Displaying "Media Feed Fault" Message
The printer displays this message when the Black Bar Sensor sensitivity level
is greater than required. The Black Bar Sensor is receiving light reflecting
from the black bar, indicating a black bar with reflective qualities. Resolving
Troubleshooting Guide
CANCEL
59
MENU
key. This
key and repeat the
Advertisement
Table of Contents
