Installing An Accessible Drive - Fujitsu CELSIUS R920 Operating Manual

System expansions

Installing an accessible drive

► If you are installing the drive in the upper bay and a cover (optional) is
already in place, please remove it.
or
► If you are installing the drive in the lower bay, also remove the metal panel on the drive bay.
► Fit the drive cover for the 5
the 5 / inch drive", Page
1
4
Do not throw away the cover. For cooling and protection against fire you must refit the
cover if you remove the drive again later (see
► Slide the accessible drive together with the attached drive metal plate into
the casing until it engages (1).
► Connect the cables to the drive. Make sure the polarity is correct.
► Close the casing (see
It may be necessary to modify the entry for the drive in the BIOS Setup.
The fan for the processor and the card holder must be removed so
that the data cables can be routed.
36
/ inch drive (see
1
4
35).
"Closing the casing", Page
"Fitting the drive cover for
"Removing an accessible drive", Page
1
34).
Fujitsu Technology Solutions
37).